Bias Tape Without a Bias Tape Maker

by Cameron

I had a wonderful sewing teacher when I was first learning to sew - Miss Veronica. She had been sewing for decades and had piles of wisdom to share. One of my favorite tricks she taught me is making bias tape in any size you need without a bias tape maker. While we were on our retreat last month, I shared this trick and it was a hit, so I thought I'd share it on the blog, too. Hope it's helpful!

FullSizeRender.jpg

All you'll need are some basic sewing tools: pins, a tape measure or seam gauge, iron, ironing board with cloth cover, and of course your bias cut strip of fabric. I cut my fabric at 1.5" wide to make .75" wide single fold bias tape.

IMG_4200.JPG

To start you'll put a pin through your ironing board cover once. Starting from where the pin emerges from the ironing board, measure .75" (or whatever you want the finished size of your bias tape to be - you can use a large safety pin if making wider tape) and put the end of the pin through the ironing board cover at that point. (This part is a little bit tricky to explain, but I think the picture shows your end goal.)

IMG_4201.JPG

I like to get my bias tape strips started by folding them in half width-wise and pressing. Open the bias tape up again and fold each edge in towards the center and press again. You only need about 4" of pressed tape to get going.

IMG_4202.JPG

Feed the bias tape through the opening in the pin - this can take a little bit of finagling, just like with a bias tape maker. Trim your bias tape.

IMG_4204.JPG

Pull some more bias tape through the pin, place your iron over the bias tape just to the side of the pin, and keep pulling! Go slowly and use your other hand to manipulate the bias tape about to go through the pin. Some fabrics require more manhandling than others. Also be aware of how long your iron has been face down. I like to lift my iron every 20-30 seconds.

IMG_4206.JPG

Voila! Bias tape in almost any size with out burnt fingers or extra notions. This is a great way to use up scrap fabric. I like to use shot cottons (seen here in my current favorite color, moss) for bias tape because they're soft and come in a wide variety of colors.

Happy (bias tape) making!